Return to Index  

The cross-section area of the communicating passage needs to be comparable...

July 14 2017 at 12:02 AM

Steve in NC  (Login pneuguy)
AR&P


Response to how about a square profile o-ring and would two pin holes

...to the transfer port's, which ~2mm in diameter. That's a pretty good-sized "pin" hole.
Steve

 
 Respond to this message   

Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.