One example of an Mrod regulator that doesn't need a bleed hole is the Huma

September 10 2017 at 12:09 PM

Steve in NC  (Login pneuguy)
AR&P


Response to Regulator differences

It gains access to the outside air by sealing the regulated side to the face of the gauge block instead of to the wall of the airtube, then having you remove the block front O-ring. This leaves an open air bleed path around the block and out through the gauge hole.

Pretty tricky. happy.gif

Other models replace the block altogether, and access the gauge hole that way.
Steve


    
This message has been edited by pneuguy on Sep 10, 2017 12:15 PM


 
 Respond to this message   

Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.