Weaver rails are big and ugly, especialy if no scope is fitted(using iron sights)

September 10 2017 at 12:50 PM
Scot Laughlin  (Login classicalgas)
YF


Response to How hard would it be for manufacturers to put a Weaver...

I suspect that there is supposed to be a licensing fee paid to use the patented dimensions.

The bolt down add on rail requires more wall thickness in the cylinder than some guns have, if it's going to be secure,milling a rail happens in the same setup as cutting the jaws and trigger slot I'm sure, on a CNC mill it's nothing.

The abrasive in the dovetail trick will prevent ring movement in all but the worst cases(piston slam due to poor seals)

 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.