clipping

November 13 2017 at 9:01 AM
Scot Heath  (Login ish00ttrap)
YF


Response to Question on clipping

My Independence clipped when I first got it. The shroud is centered on the barrel via brass stand-off rings and the cone at the end of the shroud is threaded into the end of the shroud. I suspected that the issue was a tolerance buildup and did the same as you, enlarged the hole slightly, no problems since. Since the clearance is small, slight deviation in the assembly could have pushed it enough in one direction to cause it to clip.

-Scot

 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.