How to adapt the Plinkster FFH to the CP-1M pistol. Rob, this may interest you.

February 3 2018 at 12:19 AM

Steve in NC  (Login pneuguy)
AR&P

The mismatch between the Plinkster FFH kit and the CP-1M pistol lies in the use of the OEM endcap to provide one of the attachment points for the grip. The replacement endcap supplied in the FFH kit (part 'M' in the installation guide) lacks the necessary screw hole, making grip attachment problematic.

So here's how to easily modify the FFH kit to work with the OEM endcap.

Notch the sides of one of the supplied spacer washers.

[linked image]

This makes it possible to push the FFH Tether through the washer...

[linked image]

...loop it over the notches...

[linked image]

...and anchor the tether to the washer.

[linked image]

This makes it possible to anchor the washer to one end of the hammer spring...

[linked image]

...and then insert the spacer washer end of the spring through the guide washer and into the hammer.
Note that this is the reverse of the Plinkster assembly in which the Pusher end of the tether goes into
the hammer. The OEM endcap can then be inserted, preserving the attachment point for the pistol grip.


[linked image]

[linked image]

[linked image]


    
This message has been edited by pneuguy on Feb 3, 2018 12:33 AM


 
 Respond to this message   
Responses


Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.