<< Previous Topic | Next Topic >>Return to Index  

Pointer on Monsoon gauge jumped off inside plastic cover

August 10 2017 at 1:28 PM
Scott  (Login smcowboy)
YF

How do I remove the plastic cover on my FX monsoon gauge to put it back on the stem. DO I have to remove the whole gauge out of the end of the tube? Thanks in advance.

 
 Respond to this message   
AuthorReply
GKU
(Login GKU)
YF12

Re: Pointer on Monsoon gauge jumped off inside plastic cover

August 10 2017, 2:25 PM 

My Cricket gauge plastic cover came off by itself one time, I just push it back on with a snap.
I would think the gauge is similar to the FX and can be safely removed with a small chisel tool wrapped with tape to prevent any scuffing of any surface, just go around and pry up slowly.
Install the needle on loosely until you calibrate it to your gauge on your CF tank, after which reinstall the plastic cover.

You don't need to degass or remove the gauge off of the AT.
Wearing a full face shield wouldn't be a bad idea too.

~ GKU

 
 Respond to this message   

Bob D.
(Login MB-BOB)
YF

X-acto knife blade pried between clear bezel and gauge body...n/t

August 10 2017, 2:29 PM 

[linked image]
www.DallasFTclub.org

 
 Respond to this message   
Scott
(Login smcowboy)
YF

Thanks Guys

August 10 2017, 4:21 PM 

I will try the x-acto knife try.

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  

Airgun Calculators    Num of fills calc    Capacity Calc

******** Kalibrgun High quality, superb Accuracy, outstanding Value. ********





D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present.