Are Prod barrels the same diameter as regular crosman (2240, 2250, Disco) barrels?November 9 2017 at 3:02 PM
db (Login Diamondback)
Just wondering if the barrels are the same size around at the muzzle?
|This message has been edited by Diamondback on Nov 9, 2017 3:06 PM|
|Noodles (100% Positive Boi)|
|November 9 2017, 7:17 PM |
Thanks Brother Noodles. I wonder if the designs are the same, so that a 2240
|November 10 2017, 3:58 AM |
barrel could be swapped into a Prod action, & everything would line up (breech opening & transfer port hole)?
|This message has been edited by Diamondback on Nov 10, 2017 3:59 AM|
Only the OD's Are the same, The breech end, although the same diameter
|November 11 2017, 5:16 AM |
Are slightly different. You cannot swap a prod barrel for a 22XX barrel, the prod has interval oring in the barrel. You can't swap the 1720T barrels either, the transfer ports are mill different, and are slightly offset. The only thing you asked was if the OD WA the same and ye they are. I has used the prod/mrod barrel shrouds on custom 22XX 17XX Builds.
The Prod barrel has an internal O-ring to seal the
|November 10 2017, 9:35 AM |
O-ringless smooth probe. The 1720T barrels have no internal O-ring because they don't use a pellet clip/mag. So, NO the 22xx type barrel will not interchange with a Prod barrel unless you have it milled to fit an O-ring in it.
|This message has been edited by BillKE4 on Nov 10, 2017 9:37 AM|