i've got two S710 monitors how give up on the same time.
1 lites up but now high tension.
the second completely dead,
is somebody familiar whit these problems??
Scoring disabled. You must be logged in to score posts.
Hi,
the one that is dead may be the power supply IC DP104C, which seems to fail in this chassis often. The second could be a failed line output transformer. Without any voltage measurements, its difficult to tell. You could check for resistance between the EHT cap and any of the line output transformer pins; if you get infinite, its probably OK. Any reading on the meter will indicate a duff.
Scoring disabled. You must be logged in to score posts.
i have 2 of these monitors, 1 dead and 1 power led lights up bud goes out after a few seconds.
i switcht the dp104c and everything is thesame.
after this i switcht the flybacks, result, still tesame problem. so i think those parts are oké.
any further suggestions??
Scoring disabled. You must be logged in to score posts.
the one ho was dead, we found the problem, it was the on off switch (sw 601) that stayed connected with resistor R 605 (4K7).
i think it is mend to discharge the tension when you switch it off.
so we cut the resistor and now it works again with tesame switch.
the other keeps on the power led when we disconnect the high tension.
any suggestions??
Scoring disabled. You must be logged in to score posts.
hi i just baught old computer.. with compaq s710 monitor...
i don;t know how to set brightness and other display features in this monitor...
there are four buttons on the monior, captioned as : 1, <, >, 2
i dont know how to use it. . i m not getting any helo on compaq website as well..
can anybody guide me how to set display options.. right now... its too dark on my monitor. i want to increase brightness...
please respond..
thanks with best regards.
Rupesh
Scoring disabled. You must be logged in to score posts.
