tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 Monitor repair forum - Open   
Download schematics and service manuals
See our courses below


 
       
  << Previous Topic | Next Topic >>Go to monitor repair course  

adi microscan gd166 ploblem some refresh rate

August 5 2004 at 4:49 PM
No score for this post
  (no login)

can use it normally after i put switch on
but... if i change refresh rate while i play game from 1024 768
or another to 800 600 or other refresh rate
monitor has black screen... not have picture
green light is light
i can see picture again after i put switch off and on again
have b+ 83 volt when it black screen
what ploblem
i wait for your comment................ thank

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply
Richard B
(no login)

Re: adi microscan gd166 ploblem some refresh rate

No score for this post
August 5 2004, 7:32 PM 

Most likely this is due to the EHT overvolting during the refresh change, this may be due to the internal cap in the FBT going low in value.

Put up with it the cost of replacement is more than the monitor is worth.

Rich

 
Scoring disabled. You must be logged in to score posts.Respond to this message   

(no login)

Re: adi microscan gd166 ploblem some refresh rate

No score for this post
August 6 2004, 3:11 AM 

thank...rich
i will replace fbt tomorrow
in my country all of spair part very cheap
fbt cost at 3 $ us
thank again

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - adi microscan gd166 ploblem some refresh rate
  << Previous Topic | Next Topic >>Go to monitor repair course  
   TV repair course   TV repair forum     Monitor repair forum    Monitor repair course