I have a Hansol 710A Rev 11 With just a horizontal line.
I found resistors R205 & R206 completely burnt out.
R206 Could read with a meter 25 ohms.
Replaced the two resistors but they started to heat up.
I appreciate any help & if any body has a schematic.
Please send to aaatime@ihug.com.au
Kind Regards
Thomas

Hi this is in the frame output supply so I would say that IC201 has failed.

Rich

Richard thank you for your info, however I have a problem with reading the part No. on the IC 201, it looks like 8U5043 but I am not sure. Also can you tell me the value of R205 & R206 I think they are 25 ohms but not sure. I
If you have a schematic of this monitor I appreciate it if you can Email it to me.
Again thank you
Kind Regards
Thomas