tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 Monitor repair forum - Open   
Download schematics and service manuals
See our courses below


 
       
 


  << Previous Topic | Next Topic >>Go to monitor repair course  

Rich R311

December 29 2005 at 5:37 AM
No score for this post
  (no login)

 
Hello Rich

Thankyou for responding,Unfortunately it is not in the FCC database.
This is the best I can do,Model KDS AV-7FT Avitron,Board is PWB-155A1 Rev:02
KD1732PF,Manufactored May 2000. Another idea if this one is not possible,I am still
learning even though I have repaired a few monitors.The resistor was burnt but the monitor
still worked,but not properly.I measured the resistor and found it to read 1.2 ohms.Can I trust
the DVM or could the resistor because it is burnt decieve the meter.
Hope this helps Rob

P.S I also found a couple of Caps on the way out the door.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply
Rich B
(no login)

Re: Rich R311

No score for this post
December 29 2005, 4:25 PM 

Hi is their a UL number begins with "E"

Rich

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - Rich R311
  << Previous Topic | Next Topic >>Go to monitor repair course  
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement  
   TV repair course   TV repair forum     Monitor repair forum    Monitor repair course