When power supply is connected with central unit
led is off,if is disconnected power voltage is
6.33 and 11.5
if i misure with multimeter voltage on zener diode on primary section betwin + 300 v and catode of diode,
voltage is ok 5v and 12v.
resistor are ok i'have changed zener diode but like.
if i can misure on secondary with nultimeter,on opto,tension go at normal value,but i disconnected and riconnected power supply.....tension returned at 6.33 and 11.5 v
if i put in short circuit out pin of opto...tension is ok.
i have replaced electrolitic too...but nothing.
thank you
verdelli Italy
|
