tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 Monitor repair forum - Open   
Download schematics and service manuals
See our courses below


 
       
 


  << Previous Topic | Next Topic >>Go to monitor repair course  

MAGVIEW 572 BLANK

March 20 2006 at 5:25 PM
No score for this post
Marge  (Login MargeHD)

 
Hi out there:
I just tried to get my niece's computer going (E machine T1140) with her MagView 572 15" and the SCREEN IS BLANK. The light flickers around on the little group of boxes on the left. The E Machine was a gift (she has NO money) so I was hoping to get it up and running to see what she's working with. No luck. She couldn't locate her manual.Do I need the driver from the Proview site?
Any advice will be much appreciated.
MargeHD

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply
Richard B
(no login)

Re: MAGVIEW 572 BLANK

No score for this post
March 21 2006, 6:04 AM 

Hi when the computer starts to boot it is only in low resolution modes and drivers are not needed.

If the picture is still blank then try the monitor on a known working machine.

The drivers for monitors are only to tell windows what resolutions and refresh rates the monitor is capable of so if you have windows set to 800 x 600 at 60Hz refresh then 99% of PC monitors would work OK, the other 1% being so old that they do not support 800 x 600 at 60Hz.

Rich

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
 
  << Previous Topic | Next Topic >>Go to monitor repair course  
Find more forums on SchoolsCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement  
   TV repair course   TV repair forum     Monitor repair forum    Monitor repair course