tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 Monitor repair forum - Open   
Download schematics and service manuals
See our courses below


 
       
 


  << Previous Topic | Next Topic >>Go to monitor repair course  

Entering svc menu on Mitsubishi 2040u

January 11 2008 at 10:08 AM
No score for this post
Kelly Boswell  (Login kelboswell)

 
Hi!

I have two Mitsubishi DiamondPro 2040u monitors that I would like to color match. I have followed the procedures I found in here about entering the svc menu on the 2060u, but it doesn't work on this model.

If I hold down the OSD Off button while powering-up, I get "Enter Factory Mode" with a 0. If I set it to 255, then 5 and press OSD Off again, nothing happens. If I press any other button, the menu goes off, and the monitor is just in normal mode again.

Can anybody help me?

Thanks!

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
 
  << Previous Topic | Next Topic >>Go to monitor repair course  
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement  
   TV repair course   TV repair forum     Monitor repair forum    Monitor repair course