My mill

by Russ Kepler

I know my mill's had some hard times, and I'm pretty sure the original bearings are still in there. So here's a cut to compare to:

[img][linked image][/img]

1/2 newish carbide about 1000 rpm climb milling .060 deep x .5"(ish) high (not sure about the IPM, was making decent chips) running a MicroDrop lubricator to blow chips clear.

In person the cut looks a lot better. I wouldn't question the finish on a commercial part.

Posted on Jun 19, 2017, 10:10 AM

Respond to this message

Goto Forum Home
Responses

  1. That's not far off.... Doc Nickel, Jun 20, 2017

Quantcast

eXTReMe Tracker