WGP lower tube measurements?

by NotBrian

I picked up a Sanchez SM-1 body and it seems that my valves sit about a sixteenth too deep. I'm totally willing to lasercut some delrin shims to sit between the valve's o-ring and the body but I just can't figure out what the ID/OD of the shim should be. Already checked the Rat's Nest and I'm guessing if I cut a stack of 9/16 OD 1/2 ID rings in Delrin I could just drop them in the tube and the valve's o-ring should seal fine. Ideas?

Posted on Jun 28, 2017, 3:36 PM

Respond to this message

Goto Forum Home
Responses

  1. Won't seal.... Doc Nickel, Jun 28, 2017
    1. Ah. Other way- like a CCI detent ring. NotBrian, Jun 28, 2017
      1. Probably not.. Doc Nickel, Jun 29, 2017
        1. the terrible drop-in solution. NotBrian, Jun 29, 2017

Quantcast

eXTReMe Tracker