Looks pretty good

by Russ Kepler

Maybe the VFD supports a remote keypad? When I wired mine I was able to get the remote pad and I just sticky tapes it to the front of the mill below the original fwd/off/rev switch and left the feeds to the switch disconnected. I should get a new remote pad, the membrane switches on the old one are looking kind of flakey, enough so that I indicate edges in reverse to spare the forward switch.

In the 20+ years since I've never cleaned up the install, I'll get to it someday...

Posted on Jul 6, 2017, 6:16 AM

Respond to this message

Goto Forum Home

  1. Remote controls.... Doc Nickel, Jul 6, 2017


eXTReMe Tracker