It's not a propane fitting

by James

I know the part you're referring to, it's not that. I used to be a gas appliance engineer. For one thing the larger end is sealed. I agree with you though that it looks similar.

It's not visible in the photo, but there are two holes near the major diameter almost certainly for a pin spanner wrench to grip.

My army friend also immediately identified it as a mortar fuse, and I was careful not to tell him what I thought it was.

Now I'd like to figure out how to ensure it is inert so I can disassemble it.

Posted on Oct 8, 2017, 7:06 PM

Respond to this message

Goto Forum Home
Responses

  1. It has to be inert. MarkT, Oct 8, 2017
    1. That's basically my plan. James, Oct 8, 2017
      1. Inerting.... Doc Nickel, Oct 8, 2017

Quantcast

eXTReMe Tracker