Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Dremel tool

June 2 2003 at 8:04 PM
John Kapinski  (no login)
from IP address

Response to Cutting Brass, Tin and Aluminium sheet

Dremel will cut anything. Just make sure to get appropriate cutting wheels for it. For metal, brass... I think wheels #409. Set it to around 25,000 to 30,000 RPM. It will do a nice job.


 Respond to this message   

Terms and Conditions of Use
Report abuse