Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Classic poxy putty technique.

July 14 2003 at 9:24 PM		   (no login)
from IP address 65.94.183.130


Response to Weld seams
Hi Alan,

Here an easy way (with a bit of practice). Roll tiny bits of your favorite epoxy putty with lots of water under a finger until you obtain the wanted thickness.Then with the point of an exacto place the spaghetti on the location and texture with the point of a tootpick. The tootpick has to be modified in order to obtain the desired texture. Remember to dip the tootpich in water before texturing in order to avoid a suddent displacement of the seam.

The surface location of the model can also be modified (scribe, burred??) in order to corectly receive the seam.

Hope this info helps.

Regards,
Dany Mc Donald

 
 Respond to this message   


Terms and Conditions of Use Report abuse