Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Glitched job using Matt Spray!

December 3 2003 at 8:59 AM
Yang Weiqiang  (no login)
from IP address

I haev just finished a T-34 in green. I sprayed Gunze Matt onto to have a dull finish. All was well for almost 4 days. When I got home today, I was shocked to see white spots surfacing, the t-34 turn spotty white (yes after 4 days). I reckoned its the lacquer not being able to dry properly before subsequent layers(my coating is probably too thick).

a) Short of painting the tank winter white camou to cover the glitch job, or to strip off the entire paint job, what can I do to slavage the situation? Help!

 Respond to this message   

  1. Re: Glitched job using Matt Spray! - Jakko Westerbeke on Dec 4, 2003, 8:41 AM
    1. Thsk Jakko...so what my old dad said about lacquer was true afterall! - yang weiqiang on Dec 4, 2003, 8:19 PM
  2. Had exact same problem... - Kyle Novak on Dec 5, 2003, 3:48 PM

Terms and Conditions of Use
Report abuse