Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

I use Evergreen plastic strip....

September 12 2004 at 8:29 PM
Dave O'Hara  (Login DaveOHara)
Missing-Lynx members
from IP address

Response to Building sand shield strips info needed

cut to length, draw little dots where the holes go, then drill the holes, using a small drill bit chucked into a hand vise. For uniformity, I use the bolts on an old Italeri sand skirt, as a template. HTH, Dave

 Respond to this message   

  1. Thanks Dave I'll give it a go. - Alan Bessler on Sep 12, 2004, 11:50 PM

Terms and Conditions of Use
Report abuse