Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Punch and die question

December 13 2004 at 12:01 AM		   (no login)
from IP address 66.130.79.67
Hi,

I'm working on a special project in 1/16 scale. In this project, I have some wood board and I would like to reproduce the nails ( not the entire nail but just the head). I have a lot to reproduce (around 300) and I was thinking maybe I should buy a punch & die set. Waldron have 2 sets, precision and sub miniature. My question is which set is preferable to buy for this size, 1/16? I think the precision set would be good but again I was thinking if I want to work in 1/35 scale, do I have to buy the sub miniature as well?

Thank for the help

Clarence

 
 Respond to this message   
Responses

  1. How about this-- - Kingston Wong on Dec 26, 8:17 PM
    2.  


Terms and Conditions of Use Report abuse