Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

M90 Mould

April 19 2005 at 4:18 AM		   (no login)
from IP address 217.40.187.185


Response to Molds
Thanks David. I am trying the two-part mould with the seam around the bottom edge of the brim. I've done the first half and will do the second tonight. I used FIMO instead of modelling clay and will try the 'squish' method when I come to cast the resin and therefore avoid the problem of the viscous resin not wanting to flow down the pour hole. If that fails then I will cast the helmet solid with a large pour hole, probably going into the bottom of the helmet to avoid compromising the top detail.

Regards

Tim

 
 Respond to this message   


Terms and Conditions of Use Report abuse