Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Another solution

July 29 2006 at 5:59 AM
Marc Brandes  (Login marc_brandes)
Missing-Lynx members
from IP address 213.84.150.10


Response to Question regarding Part Photo Etch and Solder.

Is to soak the pe sheet in lemon juice overnight. This takes of the coating. I red this in an old thread. Carefully clean it up with dish washing detergent afterwards.


best regards,




Marc Brandes

 
 Respond to this message   


Terms and Conditions of Use
Report abuse