Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

M60 Belts

July 29 2006 at 1:29 PM
Roger Claeps  (Login rdclaeps)
Missing-Lynx members
from IP address


I'm working on a 1/35th figure that will have some M60 belts draped around the shoulders and waist. Does anyone know of a company that produces photo etched M60 belts? I have some DML belts, but having a problems getting them to contour around the body. I've tried heating the DML belts in boiling water and with a hair dryer, but not having much luck getting them to hang naturally.

thanks for any info,


 Respond to this message   

  1. Ammunition Belts - Jason Bobrowich on Jul 30, 2006, 1:08 AM
    1. Re: Ammunition Belts - rdclaeps on Jul 30, 2006, 1:12 PM
  2. If you want three dimensional belts...... - clive harman on Jul 31, 2006, 6:24 AM
  4. plastic belts - david nickels on Jul 31, 2006, 9:19 AM
    1. Re: plastic belts - rdclaeps on Jul 31, 2006, 12:58 PM

Terms and Conditions of Use
Report abuse