Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

How to make louvered part

August 6 2006 at 8:52 AM
Sam Bagby  (Login SamBagby)
Missing-Lynx members
from IP address 68.220.84.126

Hello,

I am wanting to replace the louvered side engine covers on the Tamiya Sdkfz7. Has anyone had any experience making louvered parts?

Thanks,
Sam

 
 Respond to this message   
Responses

  1. Easiest solution - Niko Asposalo on Aug 6, 2006, 3:03 PM
  2.  
  3. I use some veery thin (say 0,05mm) or.. - Fabio Bianchi on Aug 15, 2006, 3:30 PM
  4.  


Terms and Conditions of Use
Report abuse