Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

The name of the problem

August 7 2006 at 9:37 AM
Jari Lievonen  (Login JariL)
Missing-Lynx members
from IP address 213.31.196.164


Response to Soldering Basics

is most likely Eduard. Their sets are usually coated with nickel(?) which does not work well with solder. You have to rub the coating away so that the brass becomes visible. Then apply the flux on to the surface to be soldered and touch it with a soldering iron that has some solder in its tip. Then make the bond between the parts.

In my experience Aber flux is not very good but I admit that I have tried it only a couple of times. But if your problems will not go away you should perhaps try an other flux as well.

Best regards,

Jari

PS. Also Part and Voyager parts are covered with something that requires removing prior to soldering. Aber and Royal Models can be soldered stright out from the box. Lion Roar can also be soldered without problems if I remember correctly.

 
 Respond to this message   


Terms and Conditions of Use
Report abuse