Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Oh ,how many times I've done that !

January 25 2007 at 10:43 PM
Jim Krause  (Login jkrause70)
Missing-Lynx members
from IP address 72.185.185.28


Response to Pin Wash?

I though this only happened to me!!
How nice to find out I'm REALLY not the only one.
But, by many times of this I found the solution.
1. after your finished painting your base coats or camo clear coat with flat or semi gloss.
So your color will not get burn or colored by your wash.
2.your wash was to thick.(not being mean, but from my past.)
you want your wash to be more like dirty thinner than paint.
(I do about an 80-85% thinner to about 20-15% paint)
I have really hand the best luck with oils to use cheap hardware store
paint thinner.
it's mineral sprit based.
I have tried everything including artist thinners at 7-8 dollars.
3. do several light washes compared to one large wash.
let each one dry about 15-20 min.
then VERY lightly drybrush off excess.
4. then clear coat one last time.
Hope I helped you
Jim

 
 Respond to this message   


Terms and Conditions of Use
Report abuse