Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

A few ways

January 29 2007 at 8:49 AM
Clair Greenwood  (Login phant3)
Missing-Lynx members
from IP address 70.39.155.245


Response to How do I clean PE after soldering?

First alcohol will work ok like Greg said, also some windex will remove it or anything with amonia really. Last, if you have some brake cleaner in the garage it will work real good and dry fast too. Dont use carb/injector cleaner though, it will remove the flux but in its place will be a fine film of lubricant.

Clair

 
 Respond to this message   
Responses

  1. I use vinegar nt - david nickels on Jan 29, 2007, 1:41 PM
  2.  
  3. Thanks for the info. I'll try the Windex first... - Michael McDonald on Jan 29, 2007, 4:18 PM
  4.  


Terms and Conditions of Use
Report abuse