Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Yes, you can...

February 15 2007 at 2:42 PM
Scott Dimmick  (Login SEDimmick)
Missing-Lynx members
from IP address

Response to Mr. Surfacer 1200 as a Primer??

But it seriously gums up an airbrush...well not that bad, just its royal pain in the butt to clean and you have to make sure you have it all cleaned out or you won't have an operational airbrush. I use the Tamiya Grey Primer all the time and got a spray booth because of that...to cut down on the over spray. They make a Mr. Surfacer 1200 in a spray can, but that would defeat the purpose if I understand your question correctly.

 Respond to this message   

Terms and Conditions of Use
Report abuse