Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Modeling a burnt out rubber tire

June 19 2009 at 5:50 AM
Thomas Lund  (Login Thomas_Lund)
Missing-Lynx members
from IP address 93.160.120.154

Hi

I want to do a burnt out vehicle that has rubber tires and one or more of these will be burnt out as well. I have seen some pictures where the tires have been reduced to some whitish ash looking thing. Is that the general looks of burnt tires and if so - how to do it ??

Thanks
Thomas

 
 Respond to this message   
Responses

  1. MIG Pigments - Steve Kubik on Jun 20, 12:35 AM
  2.  


Terms and Conditions of Use
Report abuse