Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Thanks Ray,

June 24 2009 at 4:13 PM		   (Login ChazSpaulding)
Missing-Lynx members
from IP address 68.6.192.53


Response to Resin straigthening
Your observations are pretty much what I had assumed. I will try the steam method. I never considered that any part that is large in mass would be much of a candidate for re-shaping.
The main thing I wanted to hear was whether this process was as easy as they indicated and you confirmed my thoughts. I will contact you.

Thanks Again, Chaz

 
 Respond to this message   


Terms and Conditions of Use Report abuse