Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

tips for assembling German AFV tool holders

November 3 2009 at 2:19 PM		   (Login Totalize)
Missing-Lynx members
from IP address 72.39.24.160
Hi all, I have the Griffon model German AFV tool holders set and and am having some issues trying to get the early type tool holders to look correct. I am finding that the bending method the instructions give causes me to double bend the clamping arm and and with thin brass like this it just breaks off. For instance I have to bend the arm down then curve it and bend it back over to connect with the locking pins other side of the clamp. Here's a link to the instructions for the early (and Late) clamps.

http://www.militarymodelling.com/news/article.asp?UAN=470&SP=&v=1


Any tips or referrals to a good article on doing this would be very helpful.

Thanks,
David.


    
This message has been edited by Totalize from IP address 72.39.24.160 on Nov 3, 2009 10:50 PM


 
 Respond to this message   
Responses

  1. Re: tips for assembling German AFV tool holders - John Murcutt on Nov 4, 5:50 PM
    1. Other way around? - Owen R Auer on Nov 8, 11:39 AM
      1. Re: Other way around? - John Murcutt on Nov 8, 12:14 PM
        1. Quenching... - bobCollignon on Nov 9, 10:41 AM
          1. Thanks Guys - David DaSilva on Nov 14, 9:44 AM
     


Terms and Conditions of Use Report abuse