Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Strips

October 7 2011 at 4:07 PM		   (Login KiwiDave4)
Missing-Lynx members
from IP address 121.73.74.35


Response to Styrene Strips
I think Jim already answered that, but as for me the first obvious reason is cost. I already have a stock of sheet, it makes more sense to cut it than to buy strip material. Then there is convenience, I want a strip when I need it, and the easiest way to get it is to cut it from a sheet I already have.

But more than that there is the pleasure of modelling, which for me is solving the problems of how to make the bits I need with the material available to me.

Regards Dave

 
 Respond to this message   


Terms and Conditions of Use Report abuse