Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Rethinking

July 22 2012 at 3:12 PM		   (Login syd03qx)
from IP address 50.10.98.180


Response to casting
Hi Andrew,

I have some time to figure out the best way forward, but the following picture shows the result I want to achieve. A group in Poland fabricated the front drive sprocket/idler shown below using a road wheel with no tire and modifications to the wheel rim. Rethinking, just on a time basis it might be better just to just buy the burned wheels aftermarket set.

[linked image]

I had also thought about casing the outer wheel halves for the regular road wheels so I would only have to go through the trouble of getting the dished hub cap with it's bolt pattern right once, but I know there are other ways to solve the problem.

Regards, Chris.


    
This message has been edited by syd03qx from IP address 50.10.98.180 on Jul 22, 2012 7:09 PM
This message has been edited by syd03qx from IP address 50.10.98.180 on Jul 22, 2012 7:08 PM
This message has been edited by syd03qx from IP address 50.10.98.180 on Jul 22, 2012 3:13 PM


 
 Respond to this message   


Terms and Conditions of Use Report abuse