Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Drill bits

January 13 2016 at 3:31 PM
Chris Grove  (Login chrismmgrove)
Missing-Lynx members
from IP address 88.105.205.168


Response to Micro Drill Bit Sets

Hi Jan

Not sure where you are based, but if its UK, try Allan at . He sells (in sets or individually) very fine drill bits. The smallest I have is 0.3mm. They are very sharp, but rather brittle and all have a shank about 3mm in diameter (on which you can read the size, though faintly and sometimes very small). With that shank, you can hold them in your fingers and drill away without needing a drill. They are not, however, as long ss conventional steel drill bits.

Chris

 
 Respond to this message   
Responses

  1. Sorry... - Chris Grove on Jan 19, 2016, 11:02 AM
  2.  


Terms and Conditions of Use
Report abuse