Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Found 'em

January 23 2016 at 11:35 AM
Jan Levine  (Login JML54)
Missing-Lynx members
from IP address 72.23.139.35


Response to Micro Drill Bit Sets

I found two Tamiya metric drill bit sets: Basic Drill Set #74049 (1.0, 1.5, 2.0, 2.5, 3.0mm) and Fine Drill Set #74044 (0.3, 0.4, 0.5, 0.6, 0.8mm). Sprue Brothers carries them. They come in a small plastic box. The Fine set has stickers you can apply which note the sizes, plus a clear plastic cover sheet inside the box to help prevent the bits from flying out when you open the box.

 
 Respond to this message   


Terms and Conditions of Use
Report abuse