Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Advice on shaping resin

January 25 2016 at 3:08 PM
Michael McDonald  (Login mlmcdonald)
Missing-Lynx members
from IP address

I have the resin bumpers for the LWS, and I have to do some bending and shaping. I have never used resin before and have only a vague conviction that I should use steam. Would someone please give me some guidance.

 Respond to this message   

  1. Hot water - roy chow on Jan 25, 2016, 4:01 PM
    1. Re: Hot water - Michael McDonald on Jan 25, 2016, 4:09 PM
      1. Handling hot resin - Chris Grove on Jan 27, 2016, 4:46 PM
        1. Well, for my first time with resin, - Michael McDonald on Jan 28, 2016, 8:25 PM

Terms and Conditions of Use
Report abuse