Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Re: Best Way To Cut DIY Solid Insulation Board

February 23 2016 at 7:42 AM
Matt Leese  (Login mdlbldrmatt135)
Missing-Lynx members
from IP address 209.45.250.66


Response to Best Way To Cut DIY Solid Insulation Board

Hot Knife or Hot wire cutter make the least mess but can be $$

 
 Respond to this message   
Responses

  1. Thanks for that tip Matt. I'll look into both. n/t - Chris Johnson on Feb 23, 2016, 12:50 PM
    1. Re: Thanks for that tip Matt. I'll look into both. n/t - Matt Leese on Feb 24, 2016, 6:53 AM
      1. 3/4 inch panels - Ted Paone on Feb 24, 2016, 10:39 PM
        1. I'll Abscond With The Wife's Bread Knife And Try That! n/t - Chris Johnson on Feb 25, 2016, 10:53 AM
     


Terms and Conditions of Use
Report abuse