Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

The bit doesn't fit

March 2 2016 at 7:47 AM
Matt Nethery  (Login Retiredyank)
Missing-Lynx members
from IP address 172.10.252.177

I have a cheap, adjustable Dremel knock-off. I want to use +0.3mm bits, in it. However, the chuck's minimum diameter tolerance is 1/8". I am trying to figure out how to go about mating the two. There is too much of a gap for tape and finding the center of the socket precludes using wooden shims. Can anyone help me out?

 
 Respond to this message   
Responses

  1. collets - Matt Leese on Mar 2, 2016, 7:54 AM
    1. I will check them out. - Matt Nethery on Mar 2, 2016, 11:03 AM
     
  2. Consider a chuck - David Schemel on Mar 9, 2016, 1:04 PM
    1. I have ordered a chuck. It is not specifically for a Dremel, but looks like it will fit. - Matt Nethery on Mar 9, 2016, 3:09 PM
     
  3. With a little modification the chuck I ordered fits. - Matt Nethery on Mar 24, 2016, 8:31 AM
  4.  


Terms and Conditions of Use
Report abuse