Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Consider a chuck

March 9 2016 at 1:04 PM
David Schemel  (Login justplanestuff)
Missing-Lynx members
from IP address 152.72.151.71


Response to The bit doesn't fit

I believe Micro mark sells a chuck that will screw into a 1/8th collet. Dremel also sells a chuck but it may only fit their tools.
Thanks

Dave Schemel

Improving my modeling one mistake at a time.

 
 Respond to this message   
Responses

  1. I have ordered a chuck. It is not specifically for a Dremel, but looks like it will fit. - Matt Nethery on Mar 9, 2016, 3:09 PM
  2.  


Terms and Conditions of Use
Report abuse