Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Cutting tube

June 28 2016 at 7:51 AM
Matt Leese  (Login mdlbldrmatt135)
Missing-Lynx members
from IP address 209.45.250.66


Response to Measuring and Cutting Styrene Tube

Use a piece of 3/16" thick stock and scribe along the length. you could create an end piece that ensures you center it the same way, by lining up the previous cut.

Pic:

[linked image]


    
This message has been edited by mdlbldrmatt135 from IP address 209.45.250.66 on Jun 28, 2016 7:57 AM


 
 Respond to this message   


Terms and Conditions of Use
Report abuse