Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

pin vice

September 24 2016 at 7:03 AM
george moore  (Login Wellsbourne)
Missing-Lynx members
from IP address 92.234.205.76


Response to My pin vise ...

I have a set of pin vices that can be bought as a complete set or individually, the smallest will take v/fine drills.
One option, if you have a lathe (?) turn down the smallest holder to give a longer taper, this will make the "jaws" grip smaller diameters.

George.

 
 Respond to this message   


Terms and Conditions of Use
Report abuse