Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Can you cut a fine line, through the wheel to the post?

November 5 2016 at 5:59 AM
Matt Nethery  (Login Retiredyank)
Missing-Lynx members
from IP address 172.10.253.123


Response to Problem with smaller wheel holes stuck on wider axles...

This should relieve tension and allow the wheel to come lose.


    
This message has been edited by Retiredyank from IP address 172.10.253.123 on Nov 5, 2016 7:05 AM


 
 Respond to this message   
Responses

  1. Great idea, Batman! Well done :-) Sounds good to me... - Andrew Tomlinson on Nov 5, 2016, 10:31 AM
  2.  


Terms and Conditions of Use
Report abuse