Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

etch locating

May 10 2017 at 1:24 PM
George Proulx  (Login 48gunny)
Missing-Lynx members
from IP address 24.113.69.63


Response to Securing Minute Etch

I use extra thin plastic cement to position the etch. It will not bond but it will hold it in place so that once I like the position I can touch the edge with CA and capillary action should flow around the piece and secure it.

George


    
This message has been edited by 48gunny from IP address 24.113.69.63 on May 10, 2017 1:27 PM


 
 Respond to this message   
Responses

  1. Unfortunately, even extra-thin ca glue floods such tiny pieces. - Matt Nethery on May 10, 2017, 4:22 PM
    1. Re: Unfortunately, even extra-thin ca glue floods such tiny pieces. - Ian Alderman on May 12, 2017, 2:55 AM
      1. nt - Matt Nethery on May 14, 2017, 8:59 AM
     


Terms and Conditions of Use
Report abuse