Home > Discussion Groups > Tricks & Tips

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Once you put a decal down... they don't come back up

June 21 2017 at 9:58 AM
David Nickels  (Login djnick66)
Missing-Lynx members
from IP address

Response to Decal colour change


It would be much easier to just buy some pre cut vinyl star stencils (Eduard and others), photo-etch template/stencil, aftermarket waterslide or dry transfer stars (Archer has both) etc.

Or, you can cut your own using Tamiya wide tape or something similar. Put the tape on a piece of glass or tile, lay out the stars and cut them out with a knife. Paint the doors white, apply the star mask, and then paint the tan.

These are for aircraft but would work on armor [linked image]

This message has been edited by djnick66 from IP address on Jun 21, 2017 10:02 AM

 Respond to this message   

Terms and Conditions of Use
Report abuse