Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

 Return to Index  

Try Jewelers drill bits

July 3 2017 at 11:06 PM
Paul Krylowski  (Login Paulpk222)
Missing-Lynx members
from IP address 184.6.211.27


Response to My pin vise ...

Georg,

There are drill bits available, .5mm to 1.6mm, that all use the same shank size. The ones I own have 3/32 shanks. Very handy for drill pressses where collets are limited. Works well in my hand vice. I bought mine from a jeweler supply.

Paul

 
 Respond to this message   


Terms and Conditions of Use
Report abuse