Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

  << Previous Topic | Next Topic >>Return to Index  

Use a Pyrogravure to make holes in tarps to feed or thread tie-downs through

May 9 2012 at 4:38 PM
  (Login AndrewTomlinson2)
Missing-Lynx members
from IP address 77.98.80.240

As the pyro comes out, it produces a raised washer effect - eg as on a Tilly. Very useful and easy - saves drilling or applying PE.

I make rivets that way too, then fill them in with a fluid putty or thick glue.

Cheers
Andrew


    
This message has been edited by AndrewTomlinson2 from IP address 77.98.80.240 on May 10, 2012 5:26 PM


 
 Respond to this message   
Current Topic - Use a Pyrogravure to make holes in tarps to feed or thread tie-downs through
  << Previous Topic | Next Topic >>Return to Index  


Terms and Conditions of Use
Report abuse