Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

  << Previous Topic | Next Topic >>Return to Index  

Styrene bending & curving

January 29 2016 at 8:21 AM
Taras  (Login babaez)
Missing-Lynx members
from IP address 128.199.241.231

I'm looking for articles about technologies of styrene bending & curving. Small diameter Evergreen plastic tubes & rods.

All the best!

 
 Respond to this message   
AuthorReply
George Moore
(Login Wellsbourne)
Missing-Lynx members
92.234.205.76

Amorama website

January 31 2016, 6:13 AM 

There are some tips on this on the Armorama website....some good discussions and examples.
You will need to keep scrolling down through the subjects.


George

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  


Terms and Conditions of Use
Report abuse